Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Painting doesn't adhere on gooseneck of lamps

We are a metal fabrication industry in India. We have received large enquiries for manufacture of gooseneck (flexible metal shafts) for lamps. However we are unable to paint the said surface as it keeps peeling off. We have been doing powder coating. Plating the same has given good result but painting has not succeeded. please advice.

Sandeep Menon
Engineer - Bangalore, India
December 1, 2010

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: