Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Need consulting on setting up R2R plating line

October 4, 2010

I am in need of an experienced consultant who can provide preliminary cost analysis and equipment design for a roll-to-roll electroplating line. Experience with non-aqueous electrodeposition, R2R electrodeposition, and plating in inert environments is a plus.

Will DelHagen
Battery manufacturer - Menlo Park, California, USA

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: