No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Powder coating a magnet?

Can I powder coat magnets inside DC motor. Over time magnets became brittle and small
chunks seize the motor, so I thought if spray coating may prevent magnets chipping.
Thanks for any suggestions.
Arthur

Arthur Obuchowicz
appliance service - Santa Rosa, California, USA
September 19, 2010

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: