No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Which is easier to finish, brass or zamak?

We are planning to introduce high quality base metal jewelry to compliment our precious metal range. We have the option of bronze, brass or zinc alloy (zamak).

From mass finishing and rhodium plating point of view, we cannot decide which metal to use.
I would appreciate if somebody can advise me , from their experience,out of three, which would be the easier for us to work with.( in theory)

Although we feel more at home with bronze or brass due to similarity in casting process, we would like to have a go at zamak from costing point of view

All suggestion appreciated

Thank you

Adam Perkins
manufacturer - Birmingham, United Kingdom
February 23, 2010

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: