No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Elevator Door Scratches

Recently, my stainless steel elevator door was scratched deeply with a key. A few choice curse words were engraved with this key. Any way to polish out the scatches?

Dave Rothschild
hotelier - Lake Charles, LA, USA
February 8, 2010

Scratches can always be polished out of metal.

Though it would probably be easier with professional polishing equipment. You should probably consult a local metal finishing job shop.

Ray Kremer
Stellar Solutions, Inc.

McHenry, Illinois

February 9, 2010

Dave, Scratch-B-Gone was developed to repair deep vandalism on elevators before it became the recommended solution for Stainless Steel appliances by all manufacturers. We have developed a power accessory process for this type of problem which quickly and permanently restores the original finish with little effort. Even you can and will be able to do this! As a service company also, we are in the field doing this type repair daily. Thanks

Barry Feinman
BarrysRestoreItAll

Carlsbad, California

February 23, 2010

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: