Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Percentage of lead consumption in continuous galvanizing line?

We would like to know the consumption of lead in the flux lines and suggestions to reduce the consumption of lead and zinc.

Pagidimarri Praveen
engineer in galvanizing shop- Lagos,Nigeria
February 4, 2010

Hi, Praveen. Please tell us the consumption of lead and zinc in your flux line so that we can understand the units and situation, and such, which you would like others to reveal to you. Thanks.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
February 5, 2010

February 5, 2010

Sir:

Is this a lead/zinc continuous sheet galvanizing line?

Regards,

Dr. Thomas H. Cook
Galvanizing Consultant - Hot Springs, South Dakota, USA

adv.
this text gets replaced with bannerText

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: