No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Aluminum polishing business start up

I am in desperate need of knowing what type of machine I should buy to start an aluminum polishing business? I see ads on the internet where they make aluminum look like chrome. The machine( if available) would have to be able to do 15-16" wheels, manifolds, intakes, etc. PLEASE ADVISE! ANYONE?

Guy Griffin
polishing - Greenville, PA, USA
December 30, 2009

Hi, Guy. The secret is not in secret software in the machine, the secret is in learning how to mirror polish aluminum, and you can do that without spending more than a couple hundred dollars. Start with letter 800 and our search engine, and then practice until you know how to mirror polish aluminum. Once you know how and all the little variables involved, you'll be able to shop for more highly automated equipment if you wish. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
December 30, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: