No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Paint peel-off test tool

Q. Resp.sir,

I just want to know about paint peel-off test tool,which has 4-8 sharp strips at bottom & handle to hold the tool. Where can I get this tool or its images, information etc.
Please assist me.

Regards

Ashish Gaikwad
Process engineer - Kalyan, Maharashtra, India
December 1, 2009

Acronyms:
GARDCO = Paul N. Gardner Co.

What you what is a "Cross Hatch Tester", they come in two sizes 2 mm and 2 mm. You can get them from the Paul N. Gardner Co. in Florida.

Ronald Zeeman
coil coating - Brampton, Ontario, Canada
February 3, 2010

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: