Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Deburring of 7" long 20T internal spline

November 25, 2009

I have approximately 2500 pieces of a driveline component that has an internal spline.

The broaching process left the splines rough to the touch and our customer does not like this.

I am looking for someone who has the capability to deburr these parts with some type of predictable process.

Rich Snyder
Automotive MFG. - Apple Creek, Ohio, USA

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: