Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

CPSIA Approved Rust Resistant Coating

September 24, 2009

I am looking for recommendations of a rust-resistant metal coating to coat/plate stamped steel parts that will comply with CPSIA and REACH requirements. Finish must have an aesthetically high quality, the color is not specific but ideally: black, chrome/polished appearance or within dark grays, but it must be uniform.

The finished components will be used in a general-consumer market. I need protection against storage, humidity & handling. I do not need salt or chemical protection.

Any advice would be greatly appreciated...Jeff

Jeff Burnham
Product Designer - Benicia, California, USA

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: