Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Reference electrodes, set-up and suppliers

September 10, 2009

I am starting a very small electropolishing bath for copper, and have figured out that I definitely need a reference electrode to accurately control the polishing conditions. Saturated calomel electrodes are continually referenced, but I don't see why a silver reference electrode wouldn't work.

Can I buy one of these from a supplier online, and how should it be wired or attached for best results in my electropolishing solution.

Regards,

David Casale
engineer - Philadelphia, Pennsylvania

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: