No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Which casting grade of aluminium allows Anodizing and Alodining?

In which grade of Aluminium casting part - both the Anodization & Alodination is possible. I tried out in ADC-12, LM-24, & LM6. LM6 is somewhat better than others. Any suggetion for other aluminium grades is welcomed.

Hariharan Asokan
project engineer - Coimbatore, Tamilnadu, India
April 13, 2009

May I know the need for doing Iodination and anodizing in the same component?

Mukundhan RaghuNathan
- Chennai, TamilNadu, India
April 18, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: