Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Need Zinc Phosphate Coating Service

I am looking for a shop that can apply zinc phosphate coating IAW DOD-P-16232 [ed. note: replaced by MIL-DTL-16232 [from DLA] ], Type Z, Class 4. The material to be coated is 4130 castings IAW MIL-6758. Castings are approximately 20 lbs each, 8" dia. x 9" high.

Jim Sutton
precision machining - Chattanooga, Tennessee, USA
March 31, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: