Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Rubber roller for tape test

I am currently looking for a roller that complies with FED-STD-141. The specs calls out for a 4 lbs rubber roller with a hardness of 70-80 using a Shore "A" durometer. Please advise.

Frank Crescini
Head of Calibration Dept. - Stockton, California, USA
January 20, 2009

I purchase my -141 rollers from a company called Gardco in FL. They also calibrate these rollers and ship w/certifications, if required.

Terry Lycans
Aerospace - Dayton, Ohio, USA
January 24, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: