No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Design of equipment for dip spin coating

We wish to develop a low cost DIP SPIN Equipment to make this process available to everybody. This will be a step towards Environmental Protection. Can anybody come forward to give/ suggest design of DIP Spin Coating M/C.

BIPIN Singh
hobbyist - INDIA
December 11, 2008

December 12, 2008

Hi, Bipin. If I were doing it, my first two steps would be to take apart an old used item to see all the details, and to do a patent search to find out what I could about the design, while at the same time finding out what I was legally prevented from doing. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

adv.: Dip-spin Coating Services

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: