No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Replacing wheels. How are aftermarket wheels?

My present aluminum wheels need replacing (2001 Toyota Solara CV). Are there safe but more economical choices for replacement than OE? How do aftermarket wheels compare to OE? Suggestions for reliable suppliers of aftermarket wheels? Thanks, Carol

Carol Emerson
- Warwick, RI. USA
October 18, 2008

Why not have your own wheels refurbished? Look up a local powder coating company in your telephone business pages or post/pose the question here in the powder coating section. Then visit them to see if the finish they obtain meets with your approval. Requires shot blasting, if they use two coats (silver + clear), the final coat must be a polyester powder.

Terry Hickling
Birmingham, United Kingdom
October 22, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: