Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Plating thickness checking in hot condition

I am working in a Brake lining manufacturing company.We have hard chrome plated compression moulds with a thickness of 25~30 microns. Moulds working temp is 150 °C. What is the facility and method available to check the plating thickness in this hot condition? I want to cary out to cross check the plating thickness online.

Kandasami Thiyagarajan
Mould management - Chennai,Tamil Nadu and India
October 6, 2008

There are magnetic devices. To my knowledge, they should work at that temperature w/o any problem. Maybe just a little re-calibration on a hot surface where the chrome thickness is known.

Guillermo Marrufo
Monterrey, NL, Mexico
October 9, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: