Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Blackening of mild steel

September 16, 2008

We need to do blackening of some hardened steel parts.
can any one suggest a procedure for the same?
Thanks in advance,

Joginadham Chilukuri, GM
flexible circuits - Hyderabad, AP, India

Hi, Joginadham. Black oxiding is certainly the easiest and most common procedure. Any reason that isn't appropriate? Please look into it and get back to us. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
September 16, 2008

adv.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: