No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

80-T vs. ASTM Specs

I am looking for a comparison of 80-T and ASTM specs. for type I, II and III anodize and passivation. As the chemistry to meet the 80-T specs. is not readily available, we are trying to give our customer an alternative that will still meet 80-T performance criteria with ASTM specs.

Rick Derrenabacher
plating shop employee - Apex, North Carolina
September 16, 2008

Hi, Rick. I have never heard of "80-T", and the question remains unanswered on finishing.com, and google shows me no pages with "80-T" and anodize. Can you either re-check for a typo or tell us where you heard of this spec? Thanks.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
November 7, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: