No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Grade of aluminum cathodes for type II Anodizing?

Hi I am a owner of a small plating jobshop and I am setting up a small type II ano line and I have been told to use only 6063 T6 aluminum what about 6061?

Carly Lawrence
owner of small job shop - Jamestown, Indiana
August 21, 2008

Use any wrought alloy. Psuedo scientist still recommend 6063. My client in Kansas used 1/6" thick 6061, 3' x 6", and it lasted over 4 years in 180 gm/L acid, then they replaced it with 1/4" thick 6061. The call out for 6063 is an overrated commercial myth.

Robert H Probert
Robert H Probert Technical Services

Garner, North Carolina

August 22, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: