Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

How do you stamp the weight into an ingot of silver or gold

I am going to make several precious metal ingots and was wondering how I would stamp the weight of each ingot into the piece? Thank You for Your Help!

Angela Rostan
Hobbyist - Connelly Springs, North Carolina
August 3, 2008

August 6, 2008

With metal stamps and a hammer. See your local tool supplier, or eBay, for metal stamps. Sizes from around 3 to 10 mm character height are readily available.

Bill Reynolds [deceased]
consultant metallurgist - Ballarat, Victoria, Australia
We sadly relate the news that Bill passed away on Jan. 29, 2010.

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: