No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

I need to build a electro polishing wand for 304 stainless

If anybody has any directions or plans it would be greatly appreciated.

Travis Armstrong
product designer - Florence, Arizona, USA
June 10, 2008

Hi, Travis. You might start by reviewing Rubinstein's "Electrochemical Metallizing" [on eBay, Amazon, AbeBooks affil links].

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
June 11, 2008

I would talk to at least two of the vendors that advertise at this site about wands, power supplies and solutions unless you have a lot of experience doing it.

James Watts
- Navarre, Florida
June 12, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: