No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Alternative process to chemical milling for aerospace

April 29, 2008

Dear sir,

Could you please give me information that which process can be an alternative process to chemical milling. we need to save time and cost by this way.

Thank you in advance.

BANU DOGANTEKIN
aerospace industry Material and Process Specialist - TURKEY

April 29, 2008

Hi, Banu. Mechanical milling? Your question seems a little too vague to me, but maybe someone who is in your same situation will be able to read between the lines and provide you with some useful ideas. Good luck.

Regards,

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: