Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 48/29

Desmutting after a boiling seal

Hi my name is Justin I am the general manager of anodizing at L.R.T. I have been trying to find a way to thoroughly de-smut parts after they have been boil sealed. Right now we have a chemical {can't think of its name} that we are trying and haven't had a whole lot of success. We also use scotchbrite,but we aren't able to get into the nooks and crannies, leaving behind an iridescent smut that can still be seen. If anyone has information on the subject your reply is greatly appreciated.

Thanks Justin

Justin Pond
- L.R.T
2000
publicly reply to Justin Pond

Which alloy(s) are you anodizing?

Tom Pullizzi
Falls Township, Pennsylvania
2000
publicly reply to Tom Pullizzi

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: