No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Shot peen prior to chromium plating on Inco 718

I am a Senior Project Engineer in the aerospace business with emphasis on reverse engineering. I am trying to determine if shot peening on Inco 718 is a typical preparation process used in chromium plating on aerospace product.

Stephen Platek
Engineer - Glastonbury, Connecticut
2007

I can respond generically that it is not uncommon to shot peen before chrome plating, and the reason it is done is often to fight fatigue stresses by compressing the outer layer and disrupt the propagation of cracks.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2007

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: