No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Stainless wire on sail boat - corrosion due to salt water

316? SS wires used as stays on sail boat are corroding due to salt water - 8 years in the Caribbean - what now to mitigate, stop the corrosion and repair multi-stranded wire to like new condition?

Andy McCann
Mechanical Engineer - Portland, Oregon, USA
2007

If your wires are rusted on the outside, consider what the state inside is probably like. The way to get them to as-new condition is to replace them.

Boat; A hole in the water surrounded by wood into which you pour money.

Geoff Smith
Hampshire, England
2007

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: