No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Want controlled rusted finish like plasma cut edge

I am an industrial technology instructor. Some of my students who are looking to achieve the same rusted finish often seen on a variety of plasma cut sculptures. The result is thin, yet evenly oxidized patina on the surface, contrasted with the plasma cut edges. Does anyone have any suggestions how this can be replicated?

Todd Neal
Industrial Technology Instructor - Waukon, Iowa, USA
2007

Small tip plasma torch and a lot of experimentation.

James Watts
- Navarre, Florida
2007

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: