No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Finger marks on anodized surface

My name is Rajan & working in an automobile company. After Aluminium tubes are Hard Anodized & Sealed with Nickel Acetate solution,while assembly & handling, Finger marks are observed on the surface. These marks could not be cleaned by wiping with wet cloth or solvents like, Toluene, thinner etc. If left as it is the stains discolour (become brown) while heating to about 300 °C.

KEYYATH RAJAN
Anodizing of Aluminium parts - Pune, Maharashtra, India
2006

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: