Metal finishers helping each other -- No cost, No registration, No damn popups
(we earn from 'affiliate link' purchases, making the site possible)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

Thread 419/66

MIL-STD-1501 vs. SAE AMSQQC320: What are the Differences?

MIL-STD-1501 VS. SAE AMSQQC320. WHAT ARE THE DIFFERENCES? I KNOW THAT 1501 MEETS OR EXCEEDS 320 BUT PROCESS CONTROLS AND QUALITY CONTROLS ARE DIFFERENT.

Bob Doty
aerospace - Anaheim, California
2006
publicly reply to Bob Doty

October 4, 2010

What is the comparison between MIL-STD-15011 and SAE AMS2460 HARD CHROME plating. Please assist me with the comparison between the 2 specifications.
What spec is the best on Aircraft landing gears?

Best regards,
Chris

Chris van Heerden
Electro plating Section head SA Airforce - South Africa
publicly reply to Chris van Heerden

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: