Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Ni-P-MoS2 electroless composite coatings

Hello
I am working on a project about Ni-P-MoS2 electroless composite coatings, but I can not deposit the MoS2. I also used CTAB but I can not again.please guide me how I can deposit it.the temperature of solution is "85-90 C. CTAB is 45 mg/L , MoS2 is 12 g/L.

Mahmood Noroozi
university - Tehran
2006

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: