No cost, No passwords, No popup ads, No AI
-- just hobbyists & pros helping each other
we earn from 'affiliate link' purchases

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Best materials for bushes and sleeves on galvanizing line

2006

Dear Sirs,
we have a hot dip continuous galvanizing line
the sink roll sleeves and bushes material are CANALLOY
I want to know more about this material composition or if there are any other material better than CANALLOY to be used in zinc

thanks
AHMED MILAD
senior maintenance engineer

Ahmed Milad
- 10th of ramadan, EGYPT

I would like to know the chemical composition of the Canalloy used for the brushes of the Galvanising plant and its physical & metallurgical properties.

DEVENDRA AGRAWAL
- GHAZIABAD , UTTAR PRADESH, INDIA
November 4, 2008

adv.
this text gets replaced with bannerText

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: