Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

How to minimize diversion from zinc pot

Our zinc pot is ceramic type 180MT capacity then how can we minimise our most of diversion of galvanized sheet please suggest suitable thoughts.

Ravidas R. Nayak
essar steel,Hazira - Surat, Gujrat, India
2006

2006

Dear Sir,
Please phrase your question again, because what are you trying to ask nobody will understand.
regards,

Dilipkumar Singh
- Cairo, Egypt

adv.
this text gets replaced with bannerText

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: