Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Etching agents that are used for 80%Ni-20%Cr, 86%WC-10%CO-4%Cr

What are the etching agents that are used for 80%Ni-20%Cr,86%WC-10%CO-4%Cr to find their microstructure.

Rambabu Arji
- Roorkee, India
2006

Nichrome will etch is a solution containing 15.5 g of ammonium cerium nitrate, 100 ml of water and 6 ml of nitric acid.

Dr. Gary Callon
University of Dundee
Arbroath, Scotland
2006

April 21, 2009

I wish to remove a thin nichrome layer which has been evaporated onto SU8 exposed.
I am looking for a chemical formulation for etching nichrome.

Thank you,

Kamonrat Boonprakong
Student - Thailand

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: