No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Metallizing ABS/PC blends

I applied to metallizing ABS/PC blends the same methods to ABS, but I can't obtain any adhesion. Could someone help me?

Norberto martin
- Buenos Aires, Argentina
1999

Plating on ABS/PC is possible but you need a special preconditioner before the chromic etcher. Ask your supplier about it.

Sara Michaeli
Tel-Aviv-Yafo, Israel
2000

We need Nickel chrome plating on ABS/PC injection moulded component. The moulded component is good. But during plating, we notice some black pads and streaks forming. How do we avoid this? Which is the right chemistry for this? What are the basic surface preparations before plating?

Thanks,

RAMANAND KINI
- India
2003

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: