No cost, No passwords, No popup ads, No AI
-- just hobbyists & pros helping each other
we earn from 'affiliate link' purchases

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Welding on boriding surface

Hi,

Everybody I would like to know, what would happen if I welded the borided components.
Please send your valuable information as earlier as possible.

Ganesh
- Coimbatore, Tamil Nadu and India
2006

Hi we have tried with 310 material for welding after using it in liquid boriding bath and it is virtually impossible either due to heavy diffusion of borided layer or due to the frequent heating and cooling at elevated temperature during the process. Further to this an analysis is needed to be done for the extension of boriding diffusion in 310.

Chandrasekar SP
boriding and nitriding - Chennai, India
November 12, 2008

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: