No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Could you help me about step and thickness of plating?

Could you help me about step and thickness of plating (TIN PLATING, NICKEL PLATING , YELLOW ZINC PLATING AND WHITE ZINC PLATING BOTH Cr +3 AND Cr +6 , EDP BLACK and POWDER PAINT).

DANUPHOL IAMWASON
INDUSTRY - THAILAND
2006

Hello Danuphol. I think this is a very broad question :-)

A cursory reply would run a dozen pages. Please get a copy of the Metal Finishing Guidebook as a start; that will introduce the answers you seek and you can get back to us with specifics. Or get some MIL, AMS, ISO, or ASTM standards to see all the different specified thicknesses for different situations. Good luck.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2006

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: