Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Painting Industry+Roughness Value

2005

Is there any acceptance criteria in industrial Standards to reveal a relation between roughness value and paint thickness applied on the surface?
For example, is the roughness value of 30-50 enough for paint thickness less than 400 Micron?
And the last question, is there any relation between SA values of SIS and surface roughness ?

Foroozanfar GHolamreza
NIOC/POGC - Iran

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: