Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Safety question regarding electrostatic spraying

I have been a spray painter for a number of years, and in the last couple, we have been using electrostatic spray guns to apply solvent based paints on plastic for a full 8 hour shift. I have already experienced loads of shocks from grounding and KV's too high, even a couple of fires, but I was wondering if there were any long term effects to my health by using these guns and being constantly bombarded with high voltage/low amperes all day long? I can't seem to find anything related to the subject. Thanks for letting me post, and what a very informative site!

Greg Cooper
auto parts finishing - Delhi, Ontario, Canada
2005

I saw a show where a guy was bombarded with electricity and it turned him into a genius! Get your equipment grounded properly before you kill yourself, or even worse, OSHA comes in and gives the company a fine! :-)

Sheldon Taylor
supply chain electronics
Wake Forest, North Carolina
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: