No cost, No passwords, No popup ads, No AI
-- just hobbyists & pros helping each other
we earn from 'affiliate link' purchases

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

COATING WORKSHOP TOOLS

I am a craftman engaged in tools and light equipments fabrication. I now require an expertise advise on the step-by-step finishing process to protect my works (made from Iron rods, Cold rolled Iron Sheets etc) from rusting through such processes as anodising, Nickeling, Electroplating, Chroming etc.

IKOTUN BISIRIYU ADEOLA
SHERAM INDUSTRIES - ILESA. OSUN STATE, NIGERIA
2005

Even a highly simplified answer to such a broad question would take tens of thousands of words, Ikotun, and realistically nobody anywhere would volunteer even a tenth of the effort it would take. You need to start with a general metal finishing book like the Metal Finishing Guidebook. Good luck.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: