No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Why Pt layer can't stop the diffusion?

I did a test: add the pt layer in the following system:n+GaAs/Ni/Au/Ge/Ni/AU, it became n+GaAs/Ni/Au/Ge/Ni/PT/AU,in order to form a diffusion barrier between the Ni and Au layer,the pt thickness is 50nm, but the effect is opposite to our aim, after anneal at 400¡ãC/1 minute in the N2H2 gas ,the yellow AU became white! why? what's wrong with the metal system? who can give me some advice? and what metal can do the barrier layer?
thanks for your help.

Xu Yuan
student - China
2005

Pt will react with Ni at high temperature.

Xiaofeng zhao
- Manchester, UK
April 8, 2009

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: