Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Mould texturising

Sir, I would like to know the details regarding texturising of moulds and the equipments-material details
I know how to etch designs, names, flowers, etc, whish will be having a minimum gap of 5.00 mm. but textures are very minute as far as 0.5 to 0.1 mm. please let me know the details

Uday Kumar
hobbyist - Bangalore, Karnataka, India
2005

The trade secrets of these techniques are very well kept and are available only through commercial agreements. Not for free or cheap.

Guillermo Marrufo
Monterrey, NL, Mexico
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: