Hobbyists & Industry luminaries alike learn on every visit
(we earn from 'affiliate link' purchases)

Curated with aloha by
Ted Mooney, P.E. RET

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing 1989-2025

-----

Copper plating on graphite fibers

I am looking for a company for plating Copper on graphite fibers. We would like to coat 0.05, 0.1 and 0.5 micron Cu on: IM7 fiber (HEXCEL, tensile strength 5308MPa, 5 microns in diameter) or IM9 fiber (HEXCEL, tensile strength 6343MPa, 4.5 microns in diameter) or T-40 fiber (AMOCO, tensile strength 5650MPa, 5.1 microns in diameter).

Yoram Sorek
a biological research institute -Ziona, Israel
1999

I TOO AM LOOKING FOR INFORMATION ABOUT COATING COPPER ON GRAPHITE FIBERS. LET ME KNOW. THANKS.

VIJAY WANI
a chemical company - MIDLAND, Michigan
2001

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: