No passwords, No popups, No cost, No AI:
we earn from 'affiliate link' purchases, making the site possible

Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Loss of aluminum during anodizing

We outsource our aluminium sections for the process of anodising and powder coating and find that there is some loss in the weight of the material when it is received back. I would like to know if there is some prescribed standard which defines the acceptable loss in weight.

Karan Thakur
- Mumbai, Maharashtra, India
2005

Dear Karan Thakur,

You shouldn't see any weight lost except if the anodizer has forgotten the part in the eching bath.

Best regards

Anne Deacon Juhl
- - Trustrup Denmark
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: