Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Seeking shop to nickel plate fishing spoons

I'm looking for a place that can nickel plate lead fishing spoons. Anywhere from a 1/4 oz spoon up to a 3 oz spoon. Will probably do anywhere from 300-500 at a time. I know it's done somewhere, but have been unable to find out where, and approximately what the cost would be. Any help would be greatly appreciated.

John Beal
manufacture fishing lures - Warsaw, Missouri, USA
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: