Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

SCUFFING PROBLEM DURING ROLL FORMING

We are facing lot of scuffing problem during roll forming of Auto wheel rims. The material used for Roll Former Dies is D-2 hardened up to 59-62 HRC. After that dies are being chrome plated to avoid scuffing, but if after getting these dies hard chrome plated, the problem still persists. Please suggest some suitable surface coating, heat treatment, raw material to avoid scuffing problem during roll forming operation.

Dinesh Dhiman
Press Tool Making - Chandigarh, UT, India
2004

Dear Mr.Dinesh, try with nitriding process.

B.Harisankar
- Bangalore, Karnataka, India
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: