Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Need a large metal mirror

I am designing an outdoor mirror 12 feet high x 6 feet mounted on a wall. Is there any way that this mirror could be done in metal instead of glass to make it less breakable? and how is it done or who makes them.

Thank you,

Rosa Mer
interior designer - Miami, Florida, USA
2004

2004

This is not a problem. Mirrors are commonly made of stainless steel for institutional use, use in tools, etc. You can simply buy a sheet of 6 foot wide by 12 long mirror polished stainless steel. I think this might be called a #8 finish.

Another alternative, offering higher reflectivity but at much higher cost, would be to silver plate and then rhodium plate a sheet of metal.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

Please tell thatme what will be the cost of giving a #8 finish to a 0.5 feet X 50 feet sheet for mirror purpose?

Devabrat Kumar
- New Delhi, India
2005

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: