Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Metal hydroxide sludge reuse.

1999

Hi This Nadim Dahdal, am an intern at S.W.D INC we are a metal finisher company Our Waste treatment system generates sludge, and we believe that the sludge can be reused in steel mills. The sludge is made of :

CU 3330 PPM
Zn 11200 PPM
Cr 606 PPM
Ni 720 PPM
Mn 2520 PPM
So4 4270 PPM
Fe 11200 PPM
Ca 26800 PPM
Mg 477 PPM

Please if you see that the sludge could be reused in any way or if you have any questions don't hesitate to contact me. Looking forward to hear from you. Sincerely,

Nadim Dahdal
- Addison , Illinois, USA

Not a prayer, Nadim. Sorry. Start by dewatering it so that it is many times more concentrated than your analysis, then be ready to pay the price of secure landfilling or "recycling".

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: