Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

The authoritative public forum
for Metal Finishing since 1989
-----

Brass plate 800 lb bell?

I am looking for a brass plater with the capability of plating an 800 poound bell. The bell is approximately 4 feet tall and 3 1/2 feet wide. The owner of the bell lives in Saling Michigan.

Jonas McCluskey
Plating Company - Jackson, Michigan
1999

- Dear Jonas , I would think that this is a perfect job for a "Brush plater". Best regards

John Tenison - Woods
- Victoria Australia
1999

John Tenison is correct that brush plating would work well on this project. The part can be done on site or in a shop, which gives you more versatility.

David Crocker
- Valencia, California
1999

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: