Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

4145 gas nitrided steel for chroming

I would like to know if a gas nitrided surface would be piece of 4145 steel that is gas nitrided would be a bad parent surface for chroming.

Amir Waseem Khan
Down-hole drilling tools - Edmonton, Alberta, Canada
2004

In our experience, nitrided surfaces are more difficult to plate. When subject to acid prep cycles lots of smut is produced and it has to be removed to obtain good adhesion.

Guillermo Marrufo
Monterrey, NL, Mexico
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: