Sound technical content, curated with aloha by
Ted Mooney, P.E. RET
Pine Beach, NJ

finishing.com -- The Home Page of the Finishing Industry

  The authoritative public forum
  for Metal Finishing since 1989

-----

Titanium plating for cymbals

I'm going to be a student of music (drums). I recently found a cymbal co. that has "titanium" cymbals. my question is are they really titanium? the co name is laser etched into the product. I want to know how I can plate them myself so I can get rid of the co name. Thank you for your time.

Jason T [surname deleted for privacy by Editor]
student - Redlands, California, USA
2004

They could be titanium, Jason, or that could just be a trade name; sorry but I don't know. If they are titanium it is nearly impossible to plate them yourself because of the tenacious titanium oxide film which forms on titanium almost instantly. Normally, plating would not conceal the etching. Good luck.

Ted Mooney, P.E.
Striving to live Aloha
finishing.com - Pine Beach, New Jersey
2004

(No "dead threads" here! If this page isn't currently on the Hotline your Q, A, or Comment will restore it)

Q, A, or Comment on THIS thread -or- Start a NEW Thread

Disclaimer: It's not possible to fully diagnose a finishing problem or the hazards of an operation via these pages. All information presented is for general reference and does not represent a professional opinion nor the policy of an author's employer. The internet is largely anonymous & unvetted; some names may be fictitious and some recommendations might be harmful.

If you are seeking a product or service related to metal finishing, please check these Directories: